Output Standard Rated Net COP in OpenStudio different from Input Rated COP in EnergyPlus report - Unmet Hours

I'm setting efficiency (COP) of some DX Cooling Coil Single Speed in the AirLoop Packaged Rooftop Heat Pump equipment for compliance Baseline of ASHRAE 90.1. I'm setting the Rated COP field to the desired efficiency according to the standard. However, when opening the EnergyPlus results, in the report Equipment Summary, the Standard Rated Net COP is different, lower than what I had set the input. This only happens in the DX Cooling Coils, but does not happen in DX Heating Coils, where the outputs are the same as inputs. Could someone help me understand why this difference and how to properly adjust the inputs according to the standard.

How do i add an output measure to OpenStudio that shows the Monthly Overview Electricity Consumption (kWh) table for each zone in my model? - Unmet Hours

IJERPH September-1 2021 - Browse Articles

Applied Sciences, Free Full-Text

Digital Alchemy

Simulate DOE commercial reference buildings in OpenStudio - Unmet Hours

Revision history - Unmet Hours

Energies September-1 2021 - Browse Articles

Energy Modeling Training: Introduction to OpenStudio/E+ - PDF Free Download

Revision history - Unmet Hours

OpenStudio Results Measure - OpenStudio Coalition User Docs

CBECC Com UserManual, PDF, Hvac