Extra Retraction at Start - UltiMaker Cura - UltiMaker Community

Can someone explain why I am getting an extra retraction command right before my skirt starts? When I print, the filament doesn't print for sometime because of the extra retraction. I have tried it in both 3.4.1 and 3.5. Maybe I have a setting that is checked or set wrong. Below is my gcode from

Z-hop does not work when moving (cura 4.5) · Issue #7108

Negative retraction extra prime amount · Issue #2667 · Ultimaker

4.7.0] Retraction Extra Prime Amount - Only on First Layer · Issue

Extra gcode in the files from Cura. - UltiMaker Cura - UltiMaker

10 Good Reasons to Use Cura

Under Extrusion Near Z-Seam in Cura 5.0 Beta (Coasting Is Off Btw

5 Best Plug-ins for Cura

Adjust Retraction Extra Prime for Travel Distance · Issue #4744

Travel settings

Cura for Bambu X1 and P1 Series by AmaZz0r

Extra Retraction at Start - Page 2 - UltiMaker Cura - UltiMaker