PA tuning Duet3D Forum

.6mm nozzle, PETG retraction - 0.1mm coasting - 0mm PA - 0.03 cube looks great but cylinder .. these holes allign with retraction s3d config ; processName,Process1 ; applyToModels,Locking_tool_v2,Inner_Ring_v2,Outer_Ring_v1 ; profileName,E5-1-PETG 0

Technology XYZ dims *

I cobbled together a very customizable pressure advance calibration script in python for klipper : r/klippers

Big gaps at z seam when using 0.8mm nozzle (underextrusion?) - General Discussion - Klipper

PIM International Summer 2023 by Inovar Communications - Issuu

RepRap Firmware - RepRap

Trying to dial in a large DIY heated printer - Improve your 3D prints - UltiMaker Community of 3D Printing Experts

Duet 2 – erste Eindrücke –

Another Pressure Advance Tuning Tool

Load Cell Design - Developers - Klipper