Temperature Drops after Print Starts - AO-101 & AO-100 - LulzBot

Hey Guys, So I had to put in new thermistor recently, did some other structural changes (60mm height increase) and wired in a fan which isn’t currently connected. Yet now I am getting this issue with my hotend where once the print start the temperature drops even though it looks like the extruder is still rocking it. I ran PID autotune, stored the values, brought the bed and then the hotend up too 230C using Repetier. Then I dropped in the GCODE. You can see down below the temperature curve. T

Mosaic Palette Users This time, no broken splices fam so far after increasing to 4;1;4

Being a Printer Master: Managing Mass Printing in a Makerspace - Make

Make 3d printing 2014 by wattronix - Issuu

LulzBot Mini 2 Review

Flash printer - AO-101 & AO-100 - LulzBot

Temperature Drops after Print Starts - AO-101 & AO-100 - LulzBot

LulzBot Mini Review: Compact, Powerful Yet Easy to Use

Arduino « Midsouth Makers – Memphis Area Makerspace

Mimaki 3DUJ-2207 Full Color 3D Printer with Install

Review: LulzBot Mini 3D Printer - Make

I've got like an hour and a bit left of my print. Why did this happen? : r/FixMyPrint

Flash printer - AO-101 & AO-100 - LulzBot