Tuning overhangs - Bambu Studio - Bambu Lab Community Forum

I’m trying to understand how to tune overhangs for my Polymaker ASA filament. I had dialed the fan speed way down to promote layer adhesion, except for overhangs. But overhangs came out shitty: I had: 0% fan @ 35s 20% fan @ 5s 100% fan for overhangs I then adopted the bambu ASA fan settings (leaving everything else the same): 25% @ 35s 90% @ 3s 80% for overhangs The result is much better: Notice that the bad model has 100% fan for overhangs and the good one only 80%. So is less fan

Print Quality Issue, Overhangs, X1 Carbon, PLA - Bambu Studio - Bambu Lab Community Forum

Print Quality Issue, Overhangs, X1 Carbon, PLA - Bambu Studio - Bambu Lab Community Forum

TPU Vol. Flow rate issue. Any solution rather than entering speeds by calculating ? : r/BambuLab

Tuning overhangs - Bambu Studio - Bambu Lab Community Forum

Tuning overhangs - Bambu Studio - Bambu Lab Community Forum

Bambu Lab Slicer: Bambu Studio – All You Need to Know

Print Quality Issue, Overhangs, X1 Carbon, PLA - #22 by Rhotix - Bambu Studio - Bambu Lab Community Forum

Why does prusa says that x1 takes 48 minutes to print a benchy? : r/BambuLab

Tuning overhangs - Bambu Studio - Bambu Lab Community Forum